Hope this helps

- Always make sure the wireless is dissabled when accessing tools menu

- Go into tools/optons, select the list tab and turn off "Use WM5 soft buttons"
This should give you two icons aT the bottom of the  the screen while running WFFF to switch between list and radar views.

- Under the scanner tab select aggressive scanning.
Unless this is selected WFFF seems to just read the signal once as the radar/list views do not seem to update with new information.

- Once I did this I can now launch and use WFFF with wirless enabled or dissabled at startup.
- Don't forget WFFF will crash if tools is selected with wireless enabled.

I'm suprized no one at WFFF has worked on his, hmmmmm maybe its posted elseware.

Good luck ! :0)

If wifi is already running the program closes almost right away.
If enable wifi after I start the program it may or may not work for a few moments.It will crash as soon as I try to change views.

I have a HP iPAQ 111 Classic with Windows Mobile 6, Have tried the above adhoc solution with no luck. Was running previously on a Ipaq 1950 with no problems.

We need a fix

I tested it on an Eten X500 with Windows 6 and it works there without problems.

I hope the developer has time to look into this problem and solve it, because WiFiFoFum is a really great program and I'd be very happy to be able to use it.

BTW, I have an HP iPAQ 111 Classic with Windows Mobile 6, if that helps with finding a solution.

Thanks!